I plan on using a MVA sight on my Military Carbine(when it comes), the rifle comes with the Lawrence rear sight and I’m familiar with that. However I plan on using the rifle for Silhouette on occasion and wondering which tang sight you would use ? The rifle will be cambered for the venerable 40-50 SBN with a 24” barrel.
Thank you for your time.
Randy.
Sight for Military Carbine.
-
- Posts: 355
- Joined: Mon Aug 21, 2017 2:00 pm
- Location: Buffalo WY
- powderburner
- Posts: 3000
- Joined: Sat May 24, 2003 12:23 am
- Location: elko nv.
Re: Sight for Military Carbine.
My 40-50 has a 26 in barrel, I used 50 gns 1.5 OE and a 280 gn bullet and have a mid range MVA with buffalo windage. And I have shot to
980 with a few minutes left on the staff.
It wasn’t in any match , only at my range.
980 with a few minutes left on the staff.
It wasn’t in any match , only at my range.
Dean Becker
only one gun and they are 74 s
3rd asst. flunky,high desert chapter F.E.S.
MYWEIGH scale merchant
reclining member of O-G-A-N-T
only one gun and they are 74 s
3rd asst. flunky,high desert chapter F.E.S.
MYWEIGH scale merchant
reclining member of O-G-A-N-T
-
- Posts: 355
- Joined: Mon Aug 21, 2017 2:00 pm
- Location: Buffalo WY
Re: Sight for Military Carbine.
Thanks Dean that’s what I’ve been looking at, I have that sight but have decided to put a new sight on each rifle and not swap sights around anymore.
- powderburner
- Posts: 3000
- Joined: Sat May 24, 2003 12:23 am
- Location: elko nv.
Re: Sight for Military Carbine.
That’s the best way to do it if you can then you are not at the range looking for the staff or sight. It only gets tough when you have to go to scopes
Dean Becker
only one gun and they are 74 s
3rd asst. flunky,high desert chapter F.E.S.
MYWEIGH scale merchant
reclining member of O-G-A-N-T
only one gun and they are 74 s
3rd asst. flunky,high desert chapter F.E.S.
MYWEIGH scale merchant
reclining member of O-G-A-N-T