I just bought an 18 inch Malcom scope, and wanted to mount it on my Sharps. Do I have to offset it, or can in be mounted on top of the barrel?
My concern is having it interfere with the hammer.
Thank you for your input
Nick
Installing a Malcom scope
-
- Posts: 646
- Joined: Fri Nov 30, 2007 4:00 pm
Re: Installing a Malcom scope
i have 3 shilohs with mva scopes no problems art
- bpcr shooter
- Posts: 803
- Joined: Sun Feb 04, 2018 5:30 pm
- Location: Madison, Wi
Re: Installing a Malcom scope
your scope goes down the middle of your rifle, your hammer is on the side. Not sure how it would interfere with it. you need to have your barrel drilled and tapped for mounts first though, then scope rings attach to that
NMLRA Member
Winnequah Gun Club Member (Lodi, Wi)
WIFORCE Member
SCI Member
Winnequah Gun Club Member (Lodi, Wi)
WIFORCE Member
SCI Member
-
- Posts: 2173
- Joined: Tue Dec 24, 2002 7:38 pm
- Location: Hill Country, TX
Re: Installing a Malcom scope
If you're talking about one of the imported scopes, you'd probably be a lot better off and more satisfied if you save your money and b uy an MVA.
Clarence
Clarence
-
- Posts: 8428
- Joined: Wed Oct 12, 2005 10:28 pm
- Location: Not Far enough NW in Illinois
Re: Installing a Malcom scope
If you keep the scope low reaching the hammer is tight. I used a higher block combination so I can get my finger under the scope.
I found on my hunting rifle the low scope caused a problem getting a second shot chambered in the fouled barrel.
I found on my hunting rifle the low scope caused a problem getting a second shot chambered in the fouled barrel.
The reason a dog has so many friends is because he wags his tail instead of his tongue.
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery"Winston Churchill
"Socialism is a philosophy of failure, the creed of ignorance, and the gospel of envy, its inherent virtue is the equal sharing of misery"Winston Churchill