The decapping tool I sold at Quigley
-
- Posts: 34
- Joined: Wed Oct 30, 2019 10:57 am
- Location: Pocatello, Idaho
The decapping tool I sold at Quigley
To anyone that bought one of these decapping tools from me at the Quigley shoot (or anytime previously), I found that I made a mistake in the 3D printing setup that may cause the threads to fail on some of the threaded inserts (see picture) that are inside the grip on the half that catches the primer. This only affects the threads on the small insert -- the matching threads inside the grip should be fine. This insert threads out with a 1/4" nut driver. Please PM me (or email me at doug@westfork.net) with your mailing address and I'll send you a replacement insert that you can use to replace the original one if it fails.
You do not have the required permissions to view the files attached to this post.